If I am not using a DGSI readout, how can I obtain a reading in degrees C from the RTD in your sensors?

Our published instructions assume that users are reading these 2K ohm RTDs using DGSI readouts or the Campbell Scientific CR10X with AVW1 or AVW100 vibrating wire interface.

If you are using another device to read these sensors, obtain a reading in K ohms. Then apply either of the following polynomial coefficients to obtain degrees C:

Solution A: For a range of -10 to +30 C.
Ax2 + Bx + C, where x is the reading in K ohms, and:

A = -23.508334394
B = 227.625006633
C = -341.217356436

Solution B: For a range of -50 to 120 C.

Ax5 + Bx4 + Cx3 + Dx2 + Ex + F, where x is the reading in K ohms, and:

A = 0.95659
B = -12.65962
C = 70.30009
D = -216.32308
E = 483.85218
F = -472.87637